Troubleshooting - La Sommeliere CV7T Gebrauchsanweisung

8. TROUBLE SHOOTING
You can solve many common bottles cooler problems easily, saving you the cost of a possible service
call. Try the suggestions below to see if you can solve the problem before calling the servicer.
PROBLEM
Wine cooler does not operate
Wine cooler is not cold enough
Turns on and off frequently
The light does not work
Vibrations
The device seems to make too much noise
LED display is not working properly
Replacing light
This appliance consists of light-emitting diodes (LEDs). This type of diode cannot be changed by the
consumer. The lifetime of these LEDs is normally sufficient for no change to be made. If however, and
despite all the care taken during the manufacture of your device, the LEDs were defective, please
contact your after-sales service for any intervention.
POSSIBLE CAUSE
•
Not plugged in
•
The circuit breaker tripped or a blown fuse
•
Check the temperature control setting
•
External environment may require a higher
setting
•
Check that the curtain of rubber slats is
correctly positioned
•
Insufficient free space around the appliance
•
The room temperature is hotter than normal
•
The temperature control is not set correctly
•
Check that the curtain of rubber slats is
correctly positioned.
•
Not plugged in
•
The circuit breaker tripped or a blown fuse
•
The bulb has burned out
•
The light switch is "OFF"
•
Check to assure that the device is level
•
The rattling noise may come from the flow of
the refrigerant, which is normal
•
As each cycle ends, you may hear gurgling
sounds caused by the flow of refrigerant in your
wine cooler
•
Contraction and expansion of the inside walls
may cause popping and crackling noises
•
The device is not level
•
Control panel failed
•
Power PCB has broken
•
The appliance is not plugged in
•
The probe is not working
-
34