Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
water supply valve
Once all connections have been made, turn on the water supply and check for leaks carefully. If in doubt,
contact a qualified plumber.
Drain hose
•
Do not bend or pull the drain hose
•
Position the drain hose correctly, otherwise water may leak.
The end of the drain hose can be placed in two ways:
1.
Put it in the bathtub
Before placing the drain hose in the bathtub, make sure that the water drains quickly.
•
Take necessary measures to prevent slippage of the hose.
•
Recoil of an incorrectly placed hose could cause its slippage. Make sure that the plug cannot close the
drain hole of the bathtub.
•
If the hose is too long, do not push it back into the washing machine. This will cause excessive noise.
Electrical wiring
•
The washing machine requires power supply of 220-240 V, 50 Hz.
•
The power cable of your washing machine is equipped with a grounded plug. This plug should always be
inserted into a 10 A grounded outlet.
•
If you do not have a suitable outlet and a grounded fuse, consult a qualified electrician.
•
We are not liable for damage resulting from connecting the appliance to an ungrounded outlet.
Note: Operating the washing machine at low voltage shortens the service life and reduces the efficiency.
QUICK START
•
Before using the appliance for the first time, make sure that it is installed correctly.
•
Before the first wash, it is necessary to run one cycle without laundry.
10
water supply hose
2.
Connect it to the drain valve.
Werbung
Inhaltsverzeichnis
Fehlerbehebung
