Troubleshooting - Sony PMC-303L Bedienungsanleitung

Troubleshooting

Symptom
There is no audio.
"NO DISC" lights in the display
even when a CD is in place.
The CD does not play.
The sound drops out.
The audio is weak or has poor
quality.
The audio is not stereo.
The picture of your TV becomes
unstable.
The tape does not move when you
press an operation button.
The REC r button does not
function/The tape does not play.
The tape does not erase completely.
Remedy
• Press POWER to turn on the player.
• Connect the AC power cord to a wall outlet
securely.
• Adjust the volume.
• Unplug the headphones when listening through
speakers.
• Insert the CD with the label surface up.
• Make sure that the CD compartment is closed.
• Place the CD with the label surface up.
• Clean the CD.
• Take out the CD and leave the CD compartment
open for about an hour to dry moisture
condensation.
• Press p on the CD section to switch the function
of the player to "CD".
• Reduce the volume.
• Clean the CD, or replace it if the CD is badly
damaged
• Place the player in a location free from
vibration.
• Move the player away from the TV.
• If you are using the remote while listening to
MW/LW radio, noise may be heard. This is
unavoidable.
• Press STEREO/MONO/ISS on the remote until
"ST" appears.
• If you are listening to an FM program near the
TV with an indoor antenna, move the player
away from the TV.
• Close the cassette compartment securely.
• Make sure the safety tab on the cassette is in
place.
• Press p on the TAPE section to switch the
function of the player to "TAPE".
• Clean the erasing heads (see page 37.)
continued
Additional Information
35 EN