G Eneral Notes On Safety; Se Of The Machine For Purposes For Which It Is Intended; I Ncorrect Use; D Eclaration Of Incorporation - SUHNER MACHINING MAX 40 CO Betriebsanleitung

1. n
1.1 g
eneral notes on safety
This operation manual is applicable for the machine MAX
40 CO.
The machine may only be handled by personnel
who are qualified.
1.2 u
se of the machIne for purposes for
whIch It Is Intended
The machine is designed for axial and/or radial machining
like milling, drilling, reverse drilling, boring, grinding, chip
breakage, countersinking, and reverse countersinking.
This machine is specifically ideal for plant construction.
1.3 I
ncorrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 d
eclaratIon of IncorporatIon
The manufacturer SOMEX S.A.S., Z.A. La Passerelle - BP
27, F-68190 Ensisheim, hereby declares for the partly
completed machinery (see reverse side for type and se-
rial no.) that the following fundamental requirements of
the Directive 2006/42/EC are applied and fulfilled in ac-
cordance with Annex I: 1.1.2, 1.1.3, 1.1.5, 1.2.1, 1.2.2, 1.3.7,
1.3.8.1, 1.5.1, 1.5.4, and 1.6.1. Technical documentation
was generated for the partly completed machinery in ac-
cordance with Annex VII of the Machinery Directive. Docu-
ment Agent: I. Sebben. Authorised sites are provided with
this technical documentation in paper or electronic form
on justified request. This partly completed machinery may
be put into operation only when the machine in which the
partly completed machinery is to be incorporated has
been ascertained to fulfil the conditions under the Ma-
chinery Directive. F-Ensisheim, 09/2019.
I. Sebben/Division manager
2. c
2.1 a
ssembly InstructIons
Maximum admissible machine fastening
error.
The machine is fastened at the bores pro-
vided in the housing.
Screws of quality grad 8.8 must be used. The starting tor-
que for the holding down bolt is maximum 55Nm.
28
s
otEs on aFEty
oMMissioning
Connect the power supply only after the machine
has been completely installed.
2.1.1 f
astenIng of the machIne on Its mount
Correct lifting of machine with a crane.
2.2 c

onnectIng the power to the machIne

2.2.1 m
otor
The bridges must be set on the terminal board before the
motor is connected.
After the motor has been connected, the spindle's
sense of rotation must be checked. Correcting a
wrong sense of rotation involves swapping over
any two of the phase conductors.