Power Supply; Installation Of The Sealing Tape - KKT KOLBE GS60ED Benutzerhandbuch

Installation

8.4 Power supply

The mains socket must also be accessible after the device has been
!
installed.
• Prior to the electrical connection, please read the data
on the rating plate of the device, which is located inside
the device. Make sure that the voltage of the socket
corresponds to the voltage on the rating plate.
• Do not remove the rating plate because it contains
important information.
• The provided plug must be plugged into a grounded
and insulated socket.
• If the plug is no longer accessible after installation,
means for disconnection from the supply must be
incorporated in the fixed wiring with at least 3 mm
separation in all poles.
• Disturbed or damaged supply cables can only be re-
placed by a qualified person. When replacing, use the
same type of supply cable.
• Type of supply cable - H O V V - F 3G 1.5
IMPORTANT: We recommend that you do not connect
the dishwasher to an extension cable.
8.5 Installation of sealing tape
• The sealing tape must be attached to the lower side
of the worktop above your dishwasher as moisture
protection. It dissipates the steam released from your
device and protects the underside of the worktop.
• This tape can be found after unpacking inside the device.
• Before gluing the sealing tape make sure that the un-
derside of the worktop is clean.
• Remove the protective foil from the sealing tape.
• Glue the sealing tape to the underside of the worktop
Important: If no sealing tape is glued on, there is a risk
that the underside of the worktop will be damaged.
78
Rating
plate