General Troubleshooting - KKT KOLBE GS60ED Benutzerhandbuch

Troubleshooting

7.1 General troubleshooting

Problem
The dishwasher
doesn't work.
The drain pump
doesn't stop.
Sound/Noise
Mögliche Ursachen
The fuse has blown or the
safety switch of the circuit
has been actuated.
The power supply is not
turned on.
Low water pressure.
Overflow.
Some noise is normal.
The kits are not stored
in the baskets or a small
object has fallen into the
basket.
The engine „purrs".
Abhilfe
Replace the fuse or set the safety switch
of the circle. Shut off all other loads that
are connected to the same circuit as the
dishwasher.
Make sure that the dishwasher is turned
on and the door is closed properly. Make
sure that the plug of the power cable is
fully inserted into the socket.
Check that the water supply is connected
properly and that the water supply line
is open.
The system is designed so that any over-
flow is detected.
When an overflow is detected, continu-
es to run the drain pump if the unit is
powered.
During the rinse cycle, a certain operating
sound, especially when watching the food
residues are removed from the inserted
objects and when the detergent dispen-
ser pushes the tablet inside arises.
Ensure proper positioning of the objects
according to the instructions for their
contribution.
If the dishwasher doesn't work for a lon-
ger period, make sure once a week, that
the device is set to one of the washing
programs. Otherwise, the gasket can dry
out the motor and lead to higher noise
level of the machine.
71