Installation - Johnson Controls T8200-Serie Installationsanleitung

T8200
CAUTION
APPLICATION
local temperature to get comfortable environment. Select the temperature
selection

INSTALLATION

sunlight.
MOUNTING
(See Figure 3)
Note:
the insulating strip before installation (See Figure 3
Note:
CHECK-OUT PROCEDURE
Controls ® Representative.
INSTRUCTIONS
ON/OFF SETTING: press to turn on, press again to turn off, close the
MODE SELECTION: press
heating,
SETTING TEMPERATURE: Press either
FAN SPEED ADJUSTMENT
Cooling or Heating Mode Operation:
, High
the
Fan only operation:
fan. Short press the
Note:
TIME ADJUSTMENT AND TIME-ON/OFF OPERATION
Time Adjustment: Continuously press
or
"hh" in "hh:mm
Time ON/OFF Operation: Continuously press
hh:mm "ON
Press either or
Press button again until
Time ON/OFF Cancel: Continuously press
"ON "ON
00:00 button again until
00:00
P/N 24-85784-00127 Rev. A Issue date: 05 2017
or
).
Figure 4.
cooling,
or buttons to increase or
, fan. Short press
button until "mm" in "hh:mm"
button until
or
button until the
"ON
"OFF
hh:mm
or
"OFF
LOCK FUNCTION
Lock function:
Unlock function:
UNOCCUPIED MODE
.
REMOTE TEMPERATURE SENSOR
TIMER FUNCTION:
LOW TEMPERATURE PROTECTION FUNCTION:
STAND-BY FUNCTION:
CALIBRATION:
TROUBLESHOOTING
Troubles
The thermostat
cannot be
Fault Alarm:
E1
E1
, ,
!
fault alarm.
HI
Display
,
Compliance
button for 10s to enter the Timer interface,
Solutions
1.
2.
3.
4.
.
, temperature < 0 °C.
Voltage Directive.
English
button for 5s to enter
.
2