Before You Start; Operating The Laminator - HP OneLam Combo A3 Bedienungsanleitung

EN
3
Connect the power cable to the connection socket in the laminator.
4
Connect the power plug to a power socket.
5
Switch the power switch to ON.
Î The transport rollers start to rotate.
Î The "COLD" status LED lights up GREEN
Î The laminator has been put into operation.

Before You Start

Please observe the following information to ensure continued reliable operation of the laminator.
Information on the Material
■
Do not laminate metallic, wet or uneven materials.
■ The material to be laminated, including the laminating pouch, must not be thicker than 0.5 mm.
■
Thin and soft materials should be laminated in laminating pouches with the largest foil thickness
(125 µ).
■
If possible, do not use too many small pieces of material in one laminating pouch.
Information on the Laminating Pouches
■
Only use foil pouches intended for lamination purposes.
Other types of foil, such as transparent film, are not suitable for laminating.
■
Only use hot laminating pouches for "Hot laminating" operating mode.
■
Only use cold laminating pouches for "Cold laminating" operating mode.
■
Choose the size of laminating pouch according to the material to be laminated.
■
If laminating pouches need to be cut, only cut the laminating pouches after laminating.
Information on the Laminating Process
■
Do not insert an empty laminating pouch in the infeed (rear) of the laminator.
■
Do not insert a laminating pouch when rolled up into the infeed (rear) of the laminator.
■
Do not insert a laminating pouch to one side of the infeed (rear) of the laminator.
■
Always insert the laminating pouch with the closed side first, centred and straight into the infeed (rear)
of the laminator, which is ready to operate.
■
Do not pull the laminating pouch out of the output side (front) during laminating.
Please remember that hot laminated materials are permanently bonded to the laminating
pouch and cannot be separated from the foil again without possible damage.

Operating the Laminator

The following section describes how to complete hot lamination and cold lamination.
If the laminator is not used for a period of 30 minutes, the laminator enters Standby mode.
Press the "Operating mode" button to make the device operational.
1
Press the "Operating mode" button several times, if necessary, until the required type of
- 18 -