Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
Changing the Cutting Head
You can change the cutting head on the cutting device as necessary.
To obtain a new cutting head, please contact your supplier or the manufacturer.
1
Release the plastic rail (F) from its fixation.
2
Guide a suitable tool (e.g. the plastic rail or slot screwdriver) in the recess (G) beside the right-
hand holder, press the tool down and maintain the pressure.
Î The lock in the right-hand holder is released.
3
Raise the guide rail up as far as possible (H) and slide the guide rail to the right (I) until the
guide rail is released from the left-hand holder. Remove the guide rail.
Î You have disassembled the guide rail together with the cutting head.
Caution!
Risk of injury through sharp cutting device!
Do not touch the knife blades in the cutting heads to be changed.
4
Pull the old cutting head from the guide rail.
5
Assemble the new cutting head on the guide rail in the direction of installation.
6
With the lock released (=> Step 2), fit the guide rail with the cutting head firstly in the right-
hand holder and then in the left-hand holder.
7
Remove the tool from the recess and engage the lock.
8
Check that the guide rail and cutting head are fitted properly.
9
Fix the plastic rail in place.
10
Check the function of the cutting head.
Î The cutting head has been changed.
F
G
- 22 -
H
I
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
