HP OneLam Combo A3 Bedienungsanleitung Seite 19

lamination is selected.
Hot laminating: The options "125Mic" and "75Mic/80Mic" are available.
Cold laminating: On selecting the "Cold" option, cold lamination is activated.
Î One of the status LEDs (125Mic || 75Mic/80Mic) flashes GREEN and the warm-up phase
begins or the status LED (Cold) lights up GREEN continuously and the laminator is ready
to operate.
Hot laminating: After the warm-up phase has ended, a status LED lights up GREEN continu-
ously and the laminator is ready to operate.
Cold laminating: When the laminator was previously used in "Hot laminating" mode, the
laminator must be allowed to cool down for approx. 30 minutes before it is ready to operate.
Caution!
Risk of burns through hot machine surface!
The laminator heats up during hot lamination. Do not touch the device surface during
operation.
2
Place the material to be laminated inside the laminating pouch. For the best results, leave a
space of 3 mm to 5 mm at the margin on all sides.
3
Insert the laminating pouch in the infeed via the infeed tray of the laminator when ready to
operate.
Î The laminating pouch is drawn in and discharged on the output side (front) of the lamina-
tor.
Caution!
Risk of burns through hot laminating pouch.
When the laminating pouch is ejected after lamination, it is extremely hot. Only remove
the ejected lamination pouch holding it at the cooled end.
4
Remove the laminating pouch from the device.
A3 A4 A5 A6
OneLam
Combo A3
- 19 -
A6 A5 A4 A3
EN