Before You Start; Operating The Laminator - HP Pro Laminator 600 A4 Bedienungsanleitung

EN

Before You Start

Please observe the following information to ensure continued reliable operation of the laminator.
Information on the Material
■
Do not laminate metallic, wet or uneven materials.
■
The material to be laminated, including the laminating pouch, must not be thicker than 0.5 mm.
■
Thin and soft materials should be laminated in laminating pouches with the largest foil thickness
(125 µ).
■
If possible, do not use too many small pieces of material in one laminating pouch.
Information on the Laminating Pouches
■ Only use foil pouches intended for lamination purposes.
Other types of foil, such as transparent film, are not suitable for laminating.
■
Only use hot laminating pouches for "Hot laminating" operating mode.
■
Only use cold laminating pouches for "Cold laminating" operating mode.
■
Choose the size of laminating pouch according to the material to be laminated.
■
If laminating pouches need to be cut, only cut the laminating pouches after laminating.
Information on the Laminating Process
■
Do not insert an empty laminating pouch in the infeed (rear) of the laminator.
■
Do not insert a laminating pouch when rolled up into the infeed (rear) of the laminator.
■
Do not insert a laminating pouch to one side of the infeed (rear) of the laminator.
■
Always insert the laminating pouch with the closed side first, centred and straight into the infeed (rear)
of the laminator, which is ready to operate.
■
Do not pull the laminating pouch out of the output side (front) during laminating.
Please remember that hot laminated materials are permanently bonded to the laminating
pouch and cannot be separated from the foil again without possible damage.

Operating the Laminator

The following section describes how to complete hot lamination and cold lamination.
If the laminator is not used for a period of 30 minutes, the laminator enters Standby mode.
The three operating mode buttons flash BLUE. Press one of the flashing buttons so that the
laminator is ready to operate again or press the
1 Select the operating mode required by pressing one of the following buttons:
button (5) for hot lamination, 75/80 micron.
75MIC
80MIC
button (6) for hot lamination, 125 micron.
125MIC
button (7) for cold lamination at 75/80 or 125 micron.
Î Hot laminating: The selected button flashes BLUE during the warm-up phase (approx. 1
minute) and lights up BLUE continually on reaching the operating temperature.
button (9) to switch the laminator off.
- 18 -