HP OneLam Combo A3 Bedienungsanleitung Seite 21

The knife blades in the cutting head are surrounded by a protective housing.
1
Pull out the selector switch (A, B) and turn it to the required cutting pattern.
Î The selector switch latches audibly into place.
Î The cutting pattern selected is set-up.
Using the Cutting Device
1
Guide the paper/pouch between the stops and under the cutting device rail to the required
cutting position (C).
Use the positioning aids on the top of the laminator to align the material to be cut as required.
2
Press the cutting head down firmly, in order to produce a good cut and slide the cutting head
along the rail over the paper/pouch (D). Fix the material in place with your hand so that it does
not shift while being cut.
Î The paper/pouch has been cut as required.
C
- 21 -
D
EN