Ending Operation Of The Laminator; Using The Cutting Device And Corner Rounder - HP OneLam Combo A3 Bedienungsanleitung

EN
5
Switch the power switch to OFF.
Î The lamination process has been completed.
Caution!
Risk of burns through hot machine surface!
Wait a few minutes after switching off until the laminator has cooled down before you
touch it.

Ending Operation of the Laminator

Switch the laminator off when you want to stop using the laminator.
1
Switch the power switch to OFF.
2
Disconnect the power plug from the power socket.
3
Disconnect the power cable from the socket.
Î Operation of the laminator has been ended.

Using the Cutting Device and Corner Rounder

When required, you can cut the paper to be laminated or the laminating pouch to size using the
cutting device and cut the corners of the pouch with the corner rounder.
Please note that you must not insert more than three sheets of paper (80 g/m²) and not more
than one laminated document in the cutting device or corner rounder at a time.
Setting the Cutting Pattern on the Cutting Device
The cutting device is on the top side of the laminator.
The cutting device provides the following cutting patterns which can be chosen using the selector
switch on the cutting head of the cutting device.
■
straight cut,
■
wave cut,
■
perforation.
The cutting pattern set is indicated by the corresponding symbol at the top of the selector
switch.
A
- 20 -
B