Philips PerfectCare S GC7600 Serie Bedienungsanleitung Seite 13

Problem
The iron leaves a
shine or an imprint
on the garment.
The ironing board
cover becomes
wet or water
droplets come out
of the soleplate.
There is too much
steam coming out
of the iron.
4239_000_8621_3_DFU-Luxury_A5_v1.indd 13
Possible cause
The surface to be ironed
was uneven, for instance
because you were ironing
over a seam or a fold in the
garment.
Steam has condensed on
the ironing board cover
after a long ironing session.
You may have an ironing
board that is not designed
to cope with the high steam
rate of the steam generator.
The default setting of the
iron is the OptimalTemp
setting. In this setting the
iron provides a high steam
output.
This iron has been approved by The Woolmark Company Pty Ltd for
the ironing of wool only products provided that the garments are ironed
according to the instructions on the garment label and those issued by the
manufacturer of this iron. R1303. In United Kingdom, Eire, HongKong and
India, the Woolmark trademark is a Certiication trademark.
Solution
Perfect Care is safe on all garments. The shine or
imprint is not permanent and will disappear when
you wash the garment. Avoid ironing over seams or
folds or you can place a cotton cloth over the area
to be ironed to avoid imprints.
Replace the ironing board cover if the foam material
has worn out. You can also add an extra layer of felt
material under the ironing board cover to prevent
condensation on the ironing board.
Put an extra layer of felt material under the ironing
board cover to prevent condensation on the ironing
board.
Activate the ECO mode to iron with a lower
steam output. See section 'Energy saving' in this user
manual.
ENGLISH
13
10/01/14 12:20