Installation; Unpacking - Electrolux EWC1350 Benutzerinformation

8 www.electrolux.com
Water supply pressure
Water supply
Maximum Load
Spin Speed
1) Connect the water inlet hose to a water tap with a 3/4'' thread.

5. INSTALLATION

WARNING!
Refer to Safety chapters.
5.1 Lifting the machine
Incorrect methods of lifting can damage
the appliance. Open the door and take
hold of the top inside of the door
opening. You can also lift the machine by
gripping the rear overhang of the top.
WARNING!
Never lift the machine by
gripping it's control panel,
door, or detergent dispenser.

5.2 Unpacking

1. Open the door. Remove all items
from the drum.
2. Put the packaging element on the
floor behind the appliance and
carefully put it down onto its rear
side. Remove the polystyrene
protection from the bottom.
Minimum
Maximum
1)
Cotton
Maximum spin speed
0.5 bar (0.05 MPa)
8 bar (0.8 MPa)
Cold water
3 kg
1251 rpm
CAUTION!
Do not lay washing
machine on its front.
3. Put the appliance back into an
upright position. Remove the power
supply cable and the drain hose from
the hose holders.
It is possible to see
water flowing from the
drain hose. This is
because the washing
machine has been
tested at the factory.
4. Remove the three transit bolts and
pull out the plastic spacers.