Sunshower Combi White Anleitung Seite 28

INSTALLATION: CONNECTING FIXED WIRING
You can achieve the best finish by feeding the fixed wire via a hole in the wall.
Use an YmVK cable (minimum 2x 1.5mm²) for this or a similar cable with a
strong centre. Loose VD wires through a pipe or tube are not suitable. Once
you have determined the mounting height, you can easily work out where the
hole should be drilled by using the graph below. Allow the cable to stick up out
of the hole approximately 20cm.
If it is not possible to feed the fixed wiring through a hole in the wall you can
also lead the wiring from the ceiling via the wall to the Sun¬shower. Use a
cable tube to lead the cable here. The cable box must always be mounted on
the right wall. The hole for the fixed wiring can be drilled in both the left as
well as right wall.
28
De kabeldoos moet altijd op de
rechter muur worden geinstalleerd.
Het gat voor de vaste bedrading
mag zowel uit de linker als de rech-
ter muur komen.
max 100
Cable box on the right wall
place to drill
80
All dimensions are in mm