Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1. Assembling the wall module
Use the wall module (a) as a template to mark the 6 holes to be drilled on the wall. Note that the holes are
distributed evenly around the entire wall module (3 at the top, 3 at the bottom - left and right of the middle).
Ensure that the holes are at the same level and observe the minimum distance of 200 mm between the holes.
Pre-drill the markings and then drill the holes using an M10 masonry bit to a depth of at least 60 mm.
Use the rawl plugs (f) supplied for the holes and attach the wall module with the fastening screws (e) using
the washers (d).
2-A
2. Attaching the carrying arms to the rear of the plasma / LCD TV
Ensure that the carrying arms (b) are attached at the same height as close to the centre axis of the TV as
possible (see sketch 2-A). The screw holes of the carrying arms must be facing the TV. Ensure that the round
screw holes of the carrying arms are on the under side of the TV. The set includes a range of screws for
attaching the carrying arms (i–m). Please use only the screws that fit your TV! If the set does not contain
suitable screws, purchase them from a store. The set also includes plastic spacers (o, p). Use them for TVs
with a rounded or recessed rear; if the rear of the TV is flat, you do not need the spacers. Some TVs use
shortened screw threads. Use the additional washers to rectify this problem. Tighten the screws and ensure
that the carrying arms are securely fastened to the TV and cannot come loose.
Werbung
