Klarstein PopArt Bedienungsanleitung Seite 24

EN
24
Instructions for heater switch
In winter, when the room temperature is below 10 °C , to make the refrigerator
achieve good cooling effect, set the switch to "ON" position (with the "-" sign side
down). When the room temperature is above 10 °C, tplease dial the switch to the "OFF"
position in time,so that it can save energy. When you need fast cooling, set the switch
to the "ON" position (with the "-" sign side down). fast cooling is not re- quired, set the
switch to the "OFF" position. When the standard test refrigeration capacity, the switch
must be placed in the "ON" position.
Note: Some time will be required for the refrigerator to reach the set level when
temperature adjustments are made. The length of this period is determined by
difference in the existing and set temperatures, the ambient temperature, the
frequency with which the door is opened and closed and the amount of food in
storage.
Loading the refrigerator with food
When the refrigerator is switched on, do not load food until 1~2 hours have passed.
Usually, food for cold storage or deep freezing can be loaded when the temperature
inside the compartment reaches the set point.
Note: Cold storage is for short-term food storage or for daily consumption. Although
the temperature in most parts of the cold storage compartment can be regulated
between 0 and 10 degrees Centigrade, extended periods of food storage is not
recommended. Cold storage should only be used for short-term storage.