ABNOX AXDV-R1 Montageanleitung Seite 41

Pin assignment AKD controller
 STO (X1 Pin3) is the safe torque cut-off of the drive (Safe Torque Off). It is
only possible to start the drive if a 24 VDC signal is present at the input. If the
signal is removed, the engine will decelerate.
 ENABLE (X8 Pin4) is the hardware release of the drive. It is only possible to
start the drive if a 24 VDC signal is present at the input. If the signal is
removed, the engine will decelerate.
 DIGITAL-IN7 (X7 Pin2) is used to control the start command for the medium
oil. As long as a 24 VDC signal is present at the input, the drive is switched
on. If a 0 V signal is applied again, the drive brakes with a defined braking
ramp.
 DIGITAL-IN3 (X7 Pin4) is used to control the start command for the medium
grease. As long as a 24 VDC signal is present at the input, the drive is
switched on. If a 0 V signal is applied again, the drive brakes with a defined
braking ramp.
 A 24 VDC signal at input STO must always be applied first! Only then may a
24 VDC signal be applied to the ENABLE input with a delay of at least 100 ms.
 DIGITAL-OUT2 (X7 Pin5) is an output that provides a 24 VDC signal as soon
as the drive is powered up.
 FAULT (X8 Pin2) provides a 24 VDC signal if there is no fault (the
servocontroller is ready). A 0 VDC signal is present at the output if there is a
fault in the servo controller.
Speed adjustment rotary dosing unit
It is possible to adjust the rotary speed with the potentiometer (E11) from 0 to 10'000
U/min. To slow the speed down turn the potentiometer left to increase the speed turn
potentiometer right.
We recommend for grease a speed between 6000 and 10'000 U/mi.
With oil, we recommend a speed between 3000 and 6000 U/min.
Control sequence
The specified control sequence must be strictly observed in order to prevent errors in
the controller and, above all, unwanted leakage of the medium!
EN
41