Power Connection - Mettler Toledo IND560 Installationsanleitung

IND560 Installation Manual
AC power
COM1
Load cell
SW2
Fuse
SW1
Figure 2-13: Analog Main Board in Harsh Enclosure
IDNet connector
Fuse
COM1
AC power
Figure 2-14: IDNet Version in Panel-Mount Enclosure

Power Connection

A permanently attached line cord supplies the AC power to the harsh enclosure
version of the IND560 terminal. The panel-mount enclosure does not provide an
AC power cord—it is designed to have AC wiring brought directly to the rear of the
chassis and connected to the AC power terminal strip. Note that the two AC power
connections are marked "L" for line (hot) and "N" for neutral as shown in Figure
2-14. There is a loop terminal and ground screw provided for the ground
connection.
No voltage or frequency settings are required since the terminal includes a
universal power supply that operates from 85 to 264 VAC.
2-9