Lighting Instructions - Napoleon LE485SB Bedienungsanleitung

Lighting Instructions

WARNING!
WARNING!
valve.
Main Tube Burner
1. Open grill lid.
2. Push and turn any main burner
knob slowly to the 'hi' position.
This action will ignite the pilot
flame which will in turn light the
selected burner. If the pilot lights,
continue to push down on the
control knob until the burner lights
and then release.
3. If the pilot does not ignite, then
immediately turn the control knob
back to the 'off position and repeat
step 2 several times.
4. If the pilot and burner will not
ignite within 5 seconds, turn the
control knob to the 'off' position
and wait 5 minutes for any excess
gas to dissipate. Either repeat steps
2 and 3 or light with a match.
5. If lighting the unit with a
match, clip the match into the
supplied lighting rod. Hold the
lit match down through the grill
and sear plate while turning the
corresponding burner valve to high.
WARNING!
N415-0220CE-GB-DE OCT 23.17
Lights Left Burner Rear Burner
Open lid.
Ensure all burner controls are in the off position. Turn on the gas supply
Rear Burner Lighting
Lighting
2. Remove the warming rack
3. Clip a match into the supplied
lighting rod. Hold a lit match to
right end ports of rear burner. Turn
Do not use the rear burner (rotisserie burner) with the main burners operating.
Centre Burner Right Burner Side Burner Igniter
(If equipped)
1. Open grill lid.
2. Push and turn side burner control
igniter button until burner lights, or
rear burner to high.
4. If the burner will not ignite within
5 seconds, turn the control knob to
the 'off' position and wait 5 minutes
Either repeat steps 2 and 3 or light
Side Burner
Off Position
Side Burner Lighting
(If equipped)
1. Open side burner cover.
to high position.
3. Press and hold
light by match
for any excess gas to dissipate.
with a match.
www.napoleongrills.com
7
EN