Vorwerk VC100 Gebrauchsanleitung Seite 46

18
Downloaded from www.Manualslib.com
Troubleshooting
Fault
After connecting
the table vacuum
to the charging unit
or mains charger
solo, the charging
process does not
begin (no pulsating
function indicator).
The function
indicator flashes
quickly.
The Tabletop vacuum
cleaner does not
vacuum at all or not
as good as it used
to, and/it makes
abnormal sounds.
Dust leaks from
the device.
manuals search engine
Possible causes and rectification
• Ensure that the mains charger with charging unit
and the Tabletop vacuum cleaner are connected
and that the mains socket works (the function
indicator on the handle pulsates and indicates that
the Tabletop vacuum cleaner is being charged).
• Ensure that the Tabletop vacuum cleaner
is switched off for recharging.
• The Tabletop vacuum cleaner is in safety mode;
this may be due to the battery being too hot.
• Disconnect the mains charger of the Tabletop vacuum cleaner
from the mains socket and let the Tabletop vacuum cleaner
cool down.
If the problem persists, please contact
Vorwerk's customer service department.
The nozzle may be blocked.
• Switch the Tabletop vacuum cleaner
off and unblock the nozzle.
The dust chamber may not be correctly
inserted in the Tabletop vacuum cleaner.
• Insert the dust chamber into the Tabletop
vacuum cleaner properly.
The dust chamber may be full.
• Empty the dust chamber.
The dust chamber may not be correctly inserted in the device.
• Insert the dust chamber into the Tabletop
vacuum cleaner properly.
The filter unit may not have been correctly
inserted in the dust chamber.
• Insert the filter unit in the dust chamber correctly.