Espresso
approx. 40ml
Caffè crema approx. 125ml
Filter coffee approx. 125ml
This quantity can be reprogrammed according to your taste for each
beverage.
minimum quantity that can be set: approx. 30ml
maximum quantity that can be set: approx. 250ml
(filter coffee)
maximum quantity that can be set: approx. 300ml
(caffè crema, espresso)
The procedure for setting the quantity of Espresso
example.
Before brewing a coffee, check that the On/Off button
and beverage buttons are constantly lit and that
there is enough water in the tank.
Proceed as follows to reprogram the quantity of Espresso
1- Place an espresso cup under the coffee dispensing spout, chang-
ing the height of the spout or the position of the tray if neces-
sary (see section "Adjusting the dispensing height"). Insert a
new capsule as described in the previous paragraph.
2- Press and hold the Espresso button
flashes in brief intervals. Then release the button.
3- Press the Espresso button
in the cup reaches the desired level.
At this point the Espresso button
the machine will brew the same amount of coffee that was just pro-
grammed.
for the other beverages, follow the same procedure
by pressing the Caffè crema
coffee
(blue) buttons.
restoring the pre-set quantities
To reset beverages to their factory settings, with the machine off,
press and hold the On/Off
for 5 seconds. All the buttons will flash twice in confirmation.
milK carafe
The machine has a carafe for brewing cappuccino, frothed milk and
other beverages containing milk.
filling the carafe
The carafe must be cleaned before being used. Follow steps 1 to 7 as
described in the section "Weekly cleaning of the milk carafe".
is shown as an
for 3 seconds until it
again when the amount of coffee
is set. Each time it is pressed,
(yellow) or filter
and Filter coffee
(blue) buttons
To make a good quality cappuccino, use cold milk
(~5°C / 41°f) with a fat content of at least 1.5 %.
fig.1
1- Remove the carafe lid (fig.1).
2- Pour the milk into the carafe; the quantity should be between
the MIN and MAX levels (fig.2).
3- Replace the carafe lid and ensure that it is properly fitted
:
(fig.3).
inserting / removing the carafe
do not pick up the carafe by the lid as it can come
off.
Insert and remove the carafe as described.
fig.1
1- Move the carafe alongside the machine, keeping it slightly raised
(fig.1).
2- Attach the carafe to the machine by pushing down lightly until it
clicks into place (fig.2).
3- To remove the carafe, lift it and pull carefully away from the ma-
chine; it is now ready to remove (fig.3).
fig.2
fig.3
fig.2
fig.3
• 23 •