Technische Daten; Hub1418 - Ecler HUB Serie Bedienungsanleitung

TECHNISCHE DATEN

10.1 HUB1418

DIGITAL
DSP
Converters
ANALOGUE
Input 1, 2 (Line)
Input 3, 4, 5 ,6 (Mic/Line)
Input 7 to 14 (Remote Input)
Outputs 1 to 8 (Line)
Headphones output
General
Output noise floor (FFT)
CPU Floating point 32/64bit
Sampling rate 48 kHz
Latency <1.5 ms.
Resolution 24 bit, AKM
Dynamic range AD:111dB, DA: 115dB
Sensitivity +5 / -15dBV External potentiometer adjustment
Impedance >13k
Input headroom 12dBV
Connector RCA female with Euroblock stack
Type Unbalanced
Sensitivity +0 / -50dBV External potentiometer adjustment
Impedance >24k electronically balanced
Input headroom 12dBV
Connector Euroblock (Symmetrical)
Type Balanced
Pagers Input 5 and 6 (by RJ45 connector)
Phantom +48VDC (rear panel switch)
CMRR >60dB (20Hz - 20kHz)
Sensitivity 0dBV without adjustment
Impedance >24k electronically balanced
Input headroom 12dBV
Connector RJ45 Connector
Type Balanced
CMRR >60dB (20Hz - 20kHz)
Max output level 12dBV
Connector Euroblock 3-pin
Type Balanced
Selectable output From Out1 to Out8
Power >200mW – 200Ω
Connector Mini-Jack 3,5mm
External mute Normally open. Assignable to any output zone
Frequency response <10Hz ~ 20kHz (+0dB / -0.5dB)
>110dB (from 20Hz to 20kHz)
THD + Noise) < 0.005% (1kHz, 1Vrms)
Crosstalk >90dB, 20Hz - 20kHz
31