Parkside PDBS 1800 A1 Originalbetriebsanleitung Seite 8

■ Protect the hoses against kinking, constriction,
solvents and sharp edges . Keep hoses away
from heat, oil and rotating parts .
■ Ensure that the hose clamps are always tight-
ened firmly . Loose or damaged hose clamps
can allow air to escape in an uncontrolled
manner .
■ Replace a damaged hose immediately . A de-
fective supply line can cause a compressed-air
hose to thrash about and cause personal injury .
■ If the power cable of this tool is damaged, it
must be replaced by the manufacturer or its cus-
tomer service or by a similarly qualified person
in order to avoid hazards .
■ Do not use the tool if you are tired or under the
influence of drugs, alcohol or medication .
A moment of inattention when operating the
tool can result in serious personal injury .
■ Do not breathe in the exhaust air directly . Avoid
getting exhaust air in your eyes . The exhaust air
from the compressed-air tool can contain water,
oil, metal particles or dirt from the compressor .
This can cause damage to health .
WARNING!
► BE CAREFUL WHEN PUTTING DOWN THE
TOOL! Always put the tool down in such a
way that it does not lie on the trigger . Under
certain circumstances, this might cause an
accidental activation of the tool, which in turn
might lead to hazards .
■ Only suitable accessories may be used .
You can purchase these from the manufacturer .
Accessories other than original equipment can
cause hazards .
■ Use only filtered and regulated compressed
air . Dust, caustic fumes and/or moisture can
damage the motor of a compressed-air tool .
PDBS 1800 A1
■ The hose must be designed for a pressure of at
least 6 .8 bar or 125 psi, corresponding to at
least 150% of the maximum pressure generated
in the system .
■ The tool and the supply hose must be fitted
with a hose coupling that allows the pressure of
the coupling hose to be dispersed completely
during disconnection .
■ DANGER! Avoid contact with an energised line!
This tool is not insulated against electric shock .
WARNING! RISK OF INJURY!
► Under certain circumstances, high working
pressures can cause kickback to occur . This
can cause hazards due to the continuous
loading .
■ If you are inexperienced with the tool, seek
training in how to use it safely .
WARNING! RISK OF INJURY!
► RISK OF PUNCTURE WOUNDS! Do not
treat an injection wound as a simple cut .
A high-pressure jet can inject toxins into the
body and cause serious injuries . In the event
of an injection into the skin, seek medical
assistance immediately .
■ The compressed-air tool must not be modified in
any way without the manufacturer's approval .
■ Use the compressed-air tool only with the speci-
fied pressure (6 .8 bar) .
■ The compressed-air tool must always be discon-
nected from the air supply after use and for as
long as it is not in use .
■ The compressed-air tool must not be used if it is
not airtight or if it requires repair .
■ Never connect the compressed-air tool with a
compressed-air hose that exceeds a pressure
of 6 .8 bar .
GB │ CY │ 5 ■