Condensation - COMFORTPOOL EasyHeat 3 Benutzer- Und Instandhaltungshandbuch

Attention!
Ensure the power plug is
secure.
If the plug is not secure, it may
cause an electric shock,
overheating or a fire
After all connections are complete and checked, carry out the following steps:
1. Switch on the filter pump to ensure there is no water leakage in the water pipe system. Check for leaks
and verify that water is flowing from and to the swimming pool.
2. Set the thermostat to the appropriate temperature and power on the heat pump.
3. In order to protect the machine, the heat pump has a delayed start function. After the start up, the fan
starts running and then the compressor will start up automatically after about 3 minutes (see below).
4. Check if there is any abnormal noise when the heat pump is running.
5. Check that the set temperature is appropriate.
Depending on the initial temperature of the water in the swimming pool and the air temperature, it may take
several days to heat the water to the desired temperature. A good swimming pool cover can dramatically
reduce the required length of time. Isolation mats underneath will also reduce heat loss. .
Time delay - The heat pump has a built-in 3-minute start-up delay to protect the circuitry and avoid frequent
switches causing loss of function. The unit will restart automatically after this time delay expires. Even a brief
power outage can trigger this time delay and prevent the machine from restarting immediately. Power the unit
on and off during this delay does not affect the 3-minute duration of the delay.
2.5.

Condensation

The air drawn into the heat pump is strongly cooled by the operation of the heat pump for heating the pool
water, which may cause condensation on the fins of the evaporator. The amount of condensation may be as
much as several litters per hour at high relative humidity. This phenomenon is sometimes mistakenly regarded
as a water leak.
Never disconnect the power
supply while the machine is
running.
Otherwise, it may cause an
electric shock or a fire.
Never use damaged or
substandard electrical
wires.
Otherwise it may cause an
electric shock or a fire.
23