Technical Data - Cloer 7520 Bedienungsanleitung

Original Silk Screen Printing (1:1)
Original Silk Screen Printing (1:1) Original Silk Screen Printing (1:1)

Technical Data

type
752
Before the first use
• Read these operating instructions carefully before
using the appliance for the first time.
• Remove all packing parts and possibly stickers, but
not the type plate nor the serial number.
• Clean the device with a moist cloth.
• Place the coffee grinder on a dry, slip-resistant and
level surface.
EN
EC Label / Safety information
er Insert Position
Assembly
Adjusted Silk Screen Printing (1:1) Adjusted Silk Screen Printing (1:1) Adjusted Silk Screen Printing (1:1)
• To begin with, make sure that the appliance is not
connected to the mains and that the standby switch
is set to the OFF "O" position.
8
• Prior to assembly, ensure that the grinder is free of
any old coffee beans.
• Fit the grinding ring
cone (below the coffee bean receptacle
teeth of the grinding ring will fit exactly into the three
notches in of the device. Beware! Sharp edges
• Attach the empty coffee bean holder
vice. Do this by aligning the triangle on the coffee
bean holder with the grey mark on the appliance.
Now press the coffee bean holder down and turn it
clockwise towards the grinding coarseness setting.
10
volt hz
220-240 50/60
Original Silk Screen Printing (1:1)
The appliance meets the requirements
of the applicable EC directives.
The appliance is designed
for indoor domestic use only.
ATTENTION! Always unplug
the appliance when not in use
Adjusted Silk Screen Printing (1:1)
Adjust Position with Alternative Grind Level Set Adjust Position with Alternative Grind Level Se Adjust Position with Alternative Grind Level Se
and before cleaning.
incl. seal on the grinding
1
• Please note that for safety reasons, your coffee
grinder will not function if the coffee bean holder
watt
is not properly fitted.
• Now place the ground coffee receptacle with its lid
140-150
into position.
4
Operation
• Insert the plug into the socket.
• Select the desired coarseness
fee bean holder
The lower the number, the finer the degree of grinding.
Adjust Position with Alternative Grind Level Settings
The lower the number, the finer the degree of grinding.
• You can also use the cup number selector
pre-setting the grinding time.
2-12
. The three
5
• The grinder is optimised for filter coffee. A coarseness
setting between 7-9 corresponds to commercially availa-
ble ground filter coffee. The cup number selector (2-12)
is designed to grind approx. 5-7 g of coffee per cup. The
amount of ground coffee produced is also influenced by
other factors such as coffee type and moisture content.
• Pour coffee beans into the coffee bean holder
(max. 300 g).
to the de-
5
In case the coffee beans have already been added,
• Set the power switch
trical supply.
, by turning the cof-
6
.
5
NOTE
NOTE Change coarseness setting
only adjust the coarseness setting.
to ON "I" to provide the elec-
8
5
for
2
5