Operation; Maintenance - Makita 9207SPB Bedienungsanleitung

Installing or removing the wool bonnet
Fig.4
Mount the rubber pad onto the spindle. Screw the lock
nut onto the spindle.
To tighten the lock nut, hold the spindle with the wrench
so that it cannot revolve, then use the lock nut wrench
and securely tighten clockwise.
Fit the wool bonnet completely over the rubber pad and
pull the string tight. Tie a bow knot and tuck the knot and
any loose strings between the wool bonnet and the
rubber pad.
Fig.5
To remove the wool bonnet, follow the installation
procedure in reverse.

OPERATION

Polishing operation
Fig.6
CAUTION:
Always wear safety glasses or a face shield during
•
operation.
Hold the tool firmly. Turn the tool on and then apply the
wool bonnet to the workpiece.
In general, keep the wool bonnet at an angle of about 15
degrees to the workpiece surface.
Apply slight pressure only. Excessive pressure will result
in poor performance and premature wear to wool
bonnet.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Replacing carbon brushes
Fig.7
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
Fig.8
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers,
always using Makita replacement parts.
Downloaded from www.Manualslib.com manuals search engine
ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Wool bonnet 180
•
Wrench 17
•
Rubber pad 170
•
Lock nut 48
•
Lock nut wrench 28
•
Side grip (auxiliary handle)
•
6
or attachments are
Only use accessory or