Waeco PerfectView M59L Montage- Und Bedienungsanleitung Seite 50

_M59L_EB_10s.book Seite 50 Dienstag, 22. Januar 2008 4:59 16
Installing the LCD monitor
➤ Insert the connection cable plug (fig. 6 3, page 4) into the socket
➤ Connect the connection cable as follows:
➤ Lay the system cable under the dashboard.
➤ Connect the camera's connection cable to the extension cable.
➤ Lay the system cable (fig. 6 9, page 4) from the monitor to the site where
If required, additional extension cables can be obtained from your dealer or
from the manufacturer (see chapter "Accessories" on page 40).
➤ Attach the cables securely in the vehicles to prevent tripping hazards.
✓ The monitor is ready for use again.
8.3
➤ Install the connection box in a location protected from water near the
➤ Attach the connection box using the supplied screws (fig. j, page 9).
a
Connecting the control box to the power supply
➤ Connect the connection cable as follows:
50
Downloaded from www.Manualslib.com
"POWER INPUT" (fig. 0 1, page 6) of the connection box.
– Connect the red cable to terminal 15 (ignition +).
– Connect the black cable to terminal 31 (earth –).
– Connect the orange cable to the positive terminal of the reversing light.
– Connect the white cable to the positive terminal of the instrument
panel illumination.
– Connect the yellow cable to the indicator light.
you would like to mount the camera.
Use cable straps, insulating tape or glue.
Installing the connection box
monitor, preferably under the dashboard.
Make sure to consider the length of the cable.
Caution!
Make sure there is a good contact. Wrap insulating tape around
every connection on the cable (even inside the vehicle).
– Connect the red cable to the voltage supply 12 V to 24 V (maximum
30 V).
– Connect the black cable to terminal 31 (earth –).
– Connect the white cable to the control cable for switching on the
dimmer function (night mode).
manuals search engine
PerfectView