Oase AquaMax Eco Titanium 31000 Gebrauchsanweisung Seite 23

Dry installation
W A R N I N G
Possible death or severe injury from hazardous electrical voltage!
 Prior to reaching into the water, isolate (switch off and disconnect) all units/devices used in the water.
 Isolate the device (disconnect from the power supply) before carrying out any work on it.
Adhere to the following conditions for dry installation:
 E
 Swimming pond or pool that may be accessed by people.
– Install the unit at least 2 m away from the water.
 Do not expose the unit to direct sunlight.
 Place the pump in a horizontal position on a suitable base and bolt down.
 Adhere to the maximum permissible ambient temperature. Ensure forced cooling if necessary. ( Technical data)
Installation
Installation requires pipes with the following nominal widths (pipe diameters):
 AquaMax Eco Titanium 31000: DN 63
 AquaMax Eco Titanium 51000: DN 75
Fitting connections
Fit the appropriate pipe to the inlet and outlet.
AquaMax Eco Titanium 31000
How to proceed:
 H
1. Remove the protection cap.
2. For submerged installation, protect the pump inlet against unforeseeable reaching in:
– Screw a contact guard (accessory, article No. 48597) onto the inlet or
– protect the pump chamber against unauthorised access (use a padlock or screws to secure the access).
3. Connecting the pipes (DN 63)
– The position of the pump outlet can be changed. The pump casing can be turned to achieve a different position.
(→ Turning the pump casing to achieve a different position )
AquaMax Eco Titanium 51000
How to proceed:
 I
1. Remove the protection cap.
2. For submerged installation, protect the pump inlet against unforeseeable reaching in:
– Screw a contact guard (accessory, article No. 73658) to the inlet or protect the pump chamber against unauthor-
ised access (use a padlock or screws to the secure the access).
3. Connecting the pipes (DN 75)
– The position of the pump outlet can be changed. The pump casing can be turned to achieve a different position.
(→ Turning the pump casing to achieve a different position )
- EN -
23