Operation; Maintenance - Makita CL072D Bedienungsanleitung

Fig.15
5. Place the entire cloth part of the dust bag inside
the tool itself.
Fig.16
6. Close the front cover completely.
Installing the paper pack
Fig.17
1. Unfold the entrance of the paper pack before
setting it on the dust stopper.
Fig.18
Use the dust stopper also when installing dust pack. Be
careful not to take the upper side for the lower side by
mistake because they are different each other.
Fig.19
2. Insert the protrusion of the dust pack into the
groove in the dust stopper as shown in the figure.
Fig.20
3. There is no distinction between the upper and
lower sides of the dust pack. You may insert its
protrusion of any side into the lower groove of the
dust stopper.
Fig.21
4. Overlap the frame of dust stopper with that of the
dust pack.
Fig.22
5. Place the dust stopper and the dust pack together
into the cleaner cavity in the same direction of
arrow on the dust stopper. Insert them all the way
into the slots in the cleaner cavity.
Fig.23
6. Place the entire container part of the dust pack
inside the tool itself.
7. Close the front cover completely.
CAUTION:
Forgetting to install the dust bag or the dust pack,
•
failure to insert the dust stopper together with the
dust bag or the dust pack all the way into the slots
or using a broken or ripped bag, may allow dust to
get into the motor. This may result in motor failure.
Do not fold the cardboard at its opening when
•
installing the paper pack, .
Never throw away the dust stopper because it need
•
to be used repeatedly whenever either the dust bag
or the dust pack is used.
The paper pack for the cleaner is an important
•
component for maintaining the tool performance.
Using other than the genuine paper pack may
cause smokes or ignition.

OPERATION

CAUTION:
To connect attachments, such as nozzle, twist-insert
•
attachment in direction of arrow to ensure secure
Downloaded from www.Manualslib.com manuals search engine
connection during use. To disconnect attachment,
twist-extract also in direction of arrow.
Fig.24
Cleaning (Suction)
Nozzle
Attach the nozzle to clean off tables, desks, furniture, etc.
Nozzle slips on easily.
Fig.25
Nozzle + Extension wand (Straight pipe)
The extension wand fits in between the nozzle and the
cleaner itself. This arrangement is convenient for
cleaning a floor while standing erect.
Fig.26
Corner nozzle
Fit on the corner nozzle for cleaning corners and crevices
of a car or furniture.
Fig.27
Corner nozzle +Extension wand (Straight pipe)
In tight quarters where the cleaner itself cannot squeeze
in, or in high places hard to reach, use this arrangement.
Fig.28

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off before
•
attempting to perform inspection or maintenance.
After use
Fig.29
When storing the cleaner, hang it from a nail using the
hand strap.
NOTE:
Putting the cleaner against the wall without any other
•
support cause the cleaner to fall down and be damaged.
Fig.30
Cleaning
Fig.31
From time to time wipe off the outside (cleaner body) of
the cleaner using a cloth dampened in soapy water.
Clean out also the suction opening, dust bag/dust pack
mounting area and the dust stopper.
CAUTION:
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may
result.
Fig.32
Wash the dust bag in soapy water when it is clogged with
dust and the cleaner power becomes small. Dry it out
thoroughly before use. An insufficiently dried bag may
cause poor suction and shorten the service life of the motor.
8