Maintenance And Service; Maintenance And Cleaning - Bosch GSK 64 Originalbetriebsanleitung

OBJ_BUCH-1039-002.book Page 25 Thursday, January 14, 2010 6:17 PM
Changing the Workpiece Protector (see figure H)
The workpiece protector 1 at the end of the discharge
lock-off 2 protects the workpiece until the pneumatic tool
is correctly placed for the driving procedure.
The workpiece protector can be removed and replaced.
– Pull the workpiece protector from the discharge lock-
off.
– Push the new workpiece protector via the open end
over the discharge lock-off.
Note: A spare workpiece protector can be stored at the
top side of magazine 11. For this, push the workpiece
protector into the depot 9.

Maintenance and Service

Maintenance and Cleaning

If the pneumatic tool should fail despite the care taken in
manufacture and testing, repair should be carried out by
an authorised customer services agent for Bosch power
tools.
In all correspondence and spare parts orders, please al-
ways include the 10-digit article number given on the type
plate of the pneumatic tool.
¢ Have maintenance and repair work carried out only
through qualified persons. This will ensure that the
safety of the pneumatic tool is maintained.
An authorized Bosch after-sales service agent will carry
out this work quickly and reliably.
Bosch Power Tools
Downloaded from www.Manualslib.com
Disconnect the air supply before making any
adjustments, changing accessories, or plac-
ing the pneumatic tool aside. This safety
measure prevents accidental starting of the
pneumatic tool.
manuals search engine
Adjustable Air-outlet cap (see figure I)
With the adjustable exhaust cap at the air outlet 4, it is
possible to deflect the exhaust air away from yourself or
the workpiece.
Transport and Storage
For transport, disconnect the pneumatic tool from the air
supply; especially when using ladders or moving in an un-
usual stance or posture.
At the workplace, carry the pneumatic tool only by the
handle 7 and with the trigger 5 released.
Always store the pneumatic tool disconnected from the
air supply and at a clean and dry location.
When not using the pneumatic tool for a longer period of
time, cover steel parts with a fine oil coating. This pre-
vents the formation of rust.
Lubricating the Pneumatic Tool (see figure J)
When the pneumatic tool is not connected to a mainte-
nance unit, it must be lubricated at regular intervals:
– For light-duty use 1x per day.
– For heavy-duty use 2x per day.
3 drops of lubricant into air connector 8. Do not
Apply 2
–
apply too much lubricant, which could then accumulate in
the pneumatic tool and be emitted via air outlet 4.
Use only the lubricants recommended by Bosch.
– SAE 10 mineral engine oil (for use at very cold ambient
conditions)
– SAE 20 mineral engine oil
Observe all applicable environmental regulations when
disposing of old grease and solvents.
English | 25
1 609 929 U14 | (14.1.10)