Atag VA5114BT Benutzerinformation Seite 50

50
Problem and alarm code
The temperature of the wa‐
ter inside the appliance is
too high or malfunction of
the temperature sensor oc‐
curred.
• The lights related to the
programme buttons flash
6 times intermittently.
• An acoustic signal
sounds intermittently.
Technical malfunction of the
appliance.
• The lights related to the
programme buttons flash
12 times intermittently.
• An acoustic signal
sounds intermittently.
The level of water inside the
appliance is too high.
• The lights related to the
programme buttons flash
15 times intermittently.
• An acoustic signal
sounds intermittently.
The appliance stops and
starts more times during op‐
eration.
The programme lasts too
long.
Small leak from the appli‐
ance door.
The appliance door is diffi‐
cult to close.
Rattling or knocking sounds
from the inside of the appli‐
ance.
Possible cause and solution
• Make sure that the temperature of the inlet water does not
exceed 60°C.
• Switch the appliance off and on.
• Switch the appliance off and on.
• Switch the appliance off and on.
• Make sure that the filters are clean.
• Make sure that the outlet hose is installed at the right
height above the floor. Refer to the installation instruc‐
tions.
• It is normal. It provides optimal cleaning results and ener‐
gy savings.
• If the delay start option is set, cancel the delay setting or
wait for the end of the countdown.
• Activating increases the programme duration.
• The appliance is not levelled. Loosen or tighten the adjust‐
able feet (if applicable).
• The appliance door is not centred on the tub. Adjust the
rear foot (if applicable).
• The appliance is not levelled. Loosen or tighten the adjust‐
able feet (if applicable).
• Parts of the tableware are protruding from the baskets.
• The tableware is not properly arranged in the baskets. Re‐
fer to basket loading leaflet.
• Make sure that the spray arms can rotate freely.