Atag VA5114BT Benutzerinformation Seite 42

42
1. Press the release button (B) to open
the lid (C).
2. Put the detergent, in powder or tablets,
in the compartment (A).
3. If the programme has a prewash
phase, put a small quantity of
detergent on the inner part of the
appliance door.
4. Close the lid. Make sure that the
release button locks into position.
How to select and start a
programme
1. Press the button dedicated to the
programme you want to set.
The light related to the button flashes.
2. Activate if desired.
3. Close the appliance door to start the
programme.
How to select and start the
programme
1. To select , press and hold
seconds.
The light related to the button flashes.
2. Close the appliance door to start the
programme.
How to activate
1. Select a programme.
2. Press .
The light related to the button is on.
is not a permanent option
and must be activated every
time before you start a
programme.
It is not possible to activate or
deactivate
programme is running.
Activating
water and energy consumption
as well as the programme
duration.
for 3
while a
increases the
How to select and start the
programme
1. Press
The light related to the button is on.
is not applicable to this
programme.
2. Close the appliance door to start the
programme.
The appliance senses the type of load and
adjusts a suitable wash cycle.
How to delay the start of a
programme
You can delay the start of the selected
programme by 3 hours.
1. Select a programme.
2. Press .
The light related to the button is on.
3. Close the appliance door to start the
countdown.
During the countdown, it is not possible to
change the programme selection.
When the countdown is complete, the
programme starts.
How to cancel the delay start
while the countdown operates
Press and hold
The appliance returns to the programme
selection.
If you cancel the delay start,
you have to select the
programme again.
How to cancel a running
programme
Press and hold
The appliance returns to the programme
selection.
Make sure that there is
detergent in the detergent
dispenser before you start a
new programme.
.
for about 3 seconds.
for about 3 seconds.