Fcc Statement - Mitel DT690 Wichtige Benutzerinformationen

FCC Statement

This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC rules.
These limits are designed to provide reasonable pro-
tection against harmful interference in a residential
installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one or more of the fol-
lowing measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a circuit dif-
ferent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV tech-
nician for help.
--------------------------------------------------------------
Privacy of communications may not be ensured
when using this phone.
This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment. This
device complies with FCC SAR limit of 1.6 W/kg. The
highest SAR value measured when used at the ear is
0.104 W/kg. This device must not be colocated or
operating in conjunction with any other antenna or
transmitter.
• This equipment complies with Part 68 of the FCC
rules and the requirements adopted by the ACTA. On
the rear side, underneath the battery of this equip-
ment is a label that contains, among other informa-
tion, a product identifier in the format
US:AAAEQ##TXXXX. If requested, this number
must be provided to the telephone company.
Downloaded from www.Manualslib.com manuals search engine
• REN is N/A as this product is intended to be con-
nected behind a FCC Part 68 compliant PBX system.
It is not intended for direct connection to telephone
network.
• If this equipment cause harm to the telephone net-
work, the telephone company will notify you in
advance that temporary discontinuance of service
may be required. But if advance notice isn't practical,
the telephone company will notify the customer as
soon as possible. Also, you will be advised of your
right to file a complaint with the FCC if you believe it
is necessary.
• The telephone company may make changes in its
facilities, equipment, operations or procedures that
could affect the operation of the equipment. If this
happens, the telephone company will provide
advance notice in order for you to make necessary
modifications to maintain uninterrupted service.
• If trouble is experienced with this equipment, for
repair or warranty information, please contact your
Mitel business partner http://www.mitel.com.
This equipment is not intended to be repaired by the
customer (user). If the equipment is causing harm to
the telephone network, the telephone company may
request that you disconnect the equipment until the
problem is resolved.
• Connection to party line service is subject to state
tariffs. Contact the state public utility commission,
public service commission or corporation commis-
sion for information.
• If your home has specially wired alarm equipment
connected to the telephone line, ensure the installa-
tion of this equipment that it does not disable your
alarm equipment. If you have questions about what
will disable alarm equipment, consult your telephone
company or qualified installer.
Electrical Safety Advisory
Electrical surges, typically lightning transients, are
very destructive to customer terminal equipment con-
nected to AC power sources. Customer is thus rec-
ommended to use a surge arrestor for the equipment
that requires AC power.
5