Hrc1 - Count-Up; Hrc2 - Count-Down; Training Functions; Display Change - Kettler SM3610-68 Trainings- Und Bedienungsanleitung

2. Training by defaults of pulse
Manual defaults of pulse
(PROGRAM) "HRC1" Count Up"
• Press "PROGRAM" until: display: HRC1
• Press "SET": default range
Or
• Start training, all values count up.
The strain is increased automatically until the target
pulse is achieved (e.g. 130)
(PROGRAM) "HRC2" Count Down"
• Press "PROGRAM" until: display HRC2
• Press "SET": Default range
The input and adjustment possibilities are analogous
relating to the programme item "Count Down".
• Start of training
The strain is increased automatically until the target
pulse is achieved (e.g. 130)
Or
Start training
Note:
Initial strain
In HRC programmes the definition of the initial strain is
possible in the default range from level 1-10.
• Enter values by means of "Plus" or "Minus" (e.g. 10)
The strain is increased automatically from the entered
level until the target pulse is achieved (e.g. 130)
Pulse
• The pulse value can be changed at this point (readin-
ess for training) by means of "Plus" or "Minus", e.g.
from 130 to 140.
Start of training by pedalling.
Default possibilities: see table page 12
Note:
• KETTLER recommends the pulse measurement by means
of the chest belt for HRC programmes
• A strain adjustment is realised for HRC programmes in
case of deviations of +/- 6 heartbeats.

Training functions

Display change during training
Adjustment manually
By means of "PROGRAM" the display changes in the fol-
lowing order in the item field: Time / RPM / Speed /
Dist. / Pulse / Brake / Ener. / Time ...
Adjustment automatically (SCAN)
Press "PROGRAM" button for a longer period of time until
the SCAN symbol appears on the display. Change of the
displays at intervals of 5 seconds. The SCAN function is
ended by re-pressing the "PROGRAM" button, recovery
function or interruption of training.
Downloaded from www.Manualslib.com manuals search engine
SM3610-68 / SM3615-68
> >
> >
> >
>
>
27
GB