Philips FC8715 Bedienungsanleitung Seite 14

English
14
Troubleshooting
This chapter summarizes the most common problems you could encounter with the appliance. If you
are unable to solve the problem with the information below, visit www.philips.com/support for a list
of frequently asked questions or contact the Consumer Care Center in your country.
Problem
The robot does not start
cleaning when I press the
start/stop button.
The robot does not
respond when I press
one of the buttons.
The warning indicator
flashes quickly.
The robot does not clean
properly.
Possible cause
The rechargeable battery is
empty.
The robot is in deep sleep
mode.
The rechargeable battery is
empty.
One or both wheels are stuck.
One or both side brushes are
stuck.
The top cover is not present or
is not closed properly.
The bumper is stuck.
The robot was lifted while it
was cleaning.
The bristles of one or both side
brushes are crooked or bent.
The filter in the dust container
is dirty.
Solution
Charge the rechargeable battery (see
chapter 'Preparing for use').
Press the start/stop button to switch on
the robot. When you press the
start/stop button again, the robot starts
cleaning. If the battery is completely
empty, place the robot on the plugged-
in docking station..
Place the robot on the plugged-in
docking station. After a few seconds,
you will hear a beep and the display
lights up.
Remove the fluff, hair, thread or wire
that is caught around the wheel
suspension.
Clean the side brushes (see chapter
'Cleaning and maintenance').
When the top cover is not present or is
not closed properly, the robot does not
work. Place the top cover on the robot
properly.
Lift the robot so that its bumper comes
free. Place the robot at some distance
from the obstacle and press the
start/stop button to make it resume
cleaning.
Place the robot on the floor. Then press
the start/stop button to make the robot
resume cleaning.
Soak the brush or brushes in warm
water for a while. If this does not restore
the bristles to their proper shape,
replace the side brushes (see chapter
'Replacement').
Clean the filter in the dust container with
a cloth or a toothbrush with soft bristles.
You can also clean the filter and dust
container with a regular vacuum cleaner
at a low suction power setting.