Iberital Expression Two Installations- Und Betriebshandbuch Seite 54

IBERITAL
Showing the number of cycles to date. (Activations for any of the dose selections.)
Showing the total number of coff ees dispensed to date.
IMPORTANT: In order to erase the total number of coff ees and reset the counter to zero for the total number of
coff ees, press the '2 coff ees' and '2 espressos' buttons on GROUP 1 (on the left).
The display will then show:
NOTE: Erasing the total coff ee count does not erase the reading for the litres of water consumed. To eliminate
the alarm for CHANGE/REPLACE FILTER for the litres of water consumed, see the section WATER FILTER
CHANGE/REPLACEMENT ALARM.
Showing the number of coff ees by dose and by group.
Continuing to press the MENU button will show the number of coff ees by selection.
NOTE: The individual counter for coff ee dose type (1 espresso, 1 coff ee, etc.) cannot be erased.
2.9.5. Technical menu display
Remember that to access the Technical MENU, the display must be in the OFF position (the display will show the
word OFF). If it is in the ON position (the display will show the name entered), in order to access the OFF mode,
press the I/O (ON/OFF) or NON-STOP button on the left button pad and, while pressing it, also press the
TWO ESPRESSOS button on the left button pad immediately after (based on the display used).
Once in OFF mode, in order to access the technical menu, you must press the NON-STOP button on the left
button pad or the MENU button for around 10-15 seconds (based on the display used) and go into technical level
programming mode.
Page 54
Downloaded from www.Manualslib.com
- Press the MENU button and the display will show:
- Press the MENU button and the display will show:
- Press the MENU button and the display will show:
manuals search engine
Service
xxxxxx
Coffees total
xxxxxx
Coffees total
Total reset
zzzzz: 1 espresso, 1 coffee, etc.
zzzzz GR:
GR:
xxxxxx
xxxxx: No. of coffees
INSTALLATION AND OPERATION MANUAL
Group 1/2/3