Tips For An Even Faster Filter Change - Vision Aqua Verdanium Home Gebrauchsanleitung

Filter change
The pre-filters are the preliminary stage before the reverse osmosis membranes and are specifically desig-
ned to protect them. Therefore, it is necessary to change the pre-filters regularly every six months.
Changing the pre- filters regularly is also one of the warranty conditions. Thus, please observe the filter
change intervals. To change the pre-filters or the post-filters, please refer to the illustrations below and
proceed as follows:
Disconnect the device from the power supply. To do this, turn it off and pull the power cord from the
device.
Please disconnect all tubes to and from the device. Push the tubes into the connector couplings, then push
the retaining element into the connector and pull the tube out.
To change the filter units, open the right side of the
Verdanium Home.
You will need a T 20 Torx screwdriver.
Unscrew the 5 housing screws – please do not use excessive
force when loosening the screws.
After you have loosened the screws, you can remove the filter housing
cover. In the next step you can remove the pre- and post- filters.
Thanks to the tilt-able filter heads of the pre- and post-filters, you can easily remove the filters without
additional tools. Tilt the first PP filter unit forwards out of the Verdanium Home, turn the filter cartridge
90 ° anticlockwise and pull it out of the filter head.
Unscrew
50 Instruction Manual – Verdanium Home – Ver. 2.1.1 – 12.2020
Remove the second PP filter unit and the GAC post-filter from the Verdanium Home in the same way.
After removing all old filter cartridges mount the new pre- and post-filters into the filter heads in reverse
order.
Press the new filter cartridges into the filter heads of the Verdanium Home and turn them 90 ° clockwise.
Once the new filters are installed you can close the housing again and screw-on the cover. Please do not
use excessive force when tightening the screws.
Reconnect the Verdanium Home again to the withdrawal tap and any other connected devices, the water
supply and the drain. Restore the power supply and turn on the Verdanium Home.
Return the Verdanium Home to its original location. Please note the distance to the back wall of the cabi-
net should not be less than 5 cm.
Open the water supply to the unit and check the Hydro-Stopper and its battery.
Do not use rechargeable batteries in the Hydro-Stopper, just use one AA LR 6 Alkaline Battery which does
not discharge by itself and lasts in the Hydro-Stopper without any problems for one year.

Tips for an even faster filter change

1. Open withdrawal tap and keep it open
2. Wait until the unit produces ultra-pure water
3. Close the water supply to the unit
4. Wait until the display shows "Water shortage" on the display
5. Switch off Verdanium Home using power switch (on the back of the unit)
6. Unplug the power supply
7. Change pre- and post-filters
8. Re-Insert the power plug
9. Open the water supply to the unit
10. Switch on the Verdanium Home power switch (on the back of the unit)
11. Let the Verdanium Home produce ultra-pure water for approx. 4-5 minutes.
Instruction Manual – Verdanium Home – Ver. 2.1.1 – 12.2020
Filter change
51