Withdrawal Tap; Drainage - Vision Aqua Verdanium Home Gebrauchsanleitung

Withdrawal tap

Before installing the withdrawal tap, determine its installation point.
•
The withdrawal tap should be in an easy-to-use place. Please pay attention to the rotation
of the existing faucet.
•
Measure the thickness of the tabletop (40 mm max.).
•
Consider the installation and connection options under the sink.
For the bore required in the countertop or the sink, please use drill sizes 3 mm, 7 mm and 12 mm. Start with
the smallest diameter and low drill RPM and increase the speed slowly.
Use a round file to clean the bore and remove any burr residues. For installation of the withdrawal tap into
stone tabletops or sinks, (granite, marble etc.), please follow the drilling regulations of the manufacturer.
Please use the illustration below as a reference for the installation of the withdrawal tap and proceed as
follows:
•
Insert the supplied parts in the correct order on the threaded tube.
•
Correctly align the withdrawal tap.
•
Install the withdrawal tap by tightening the wing nut.
to Verdanium
Home
Both the connection to the angle valve and the Verdanium Home is under full water pressure
and should be installed with particular care. Check that both connections with the angle
valve opened are leak-proof.
38 Instruction Manual – Verdanium Home – Ver. 2.1.1 – 12.2020
Waterspout
Tap base
Tabletop
Large plastic ring washer
Wing nut
Connection adapter 1/4"
Plastic tube 1/4"
Art.-Nr.: PE-08-BI-0500F-N
You can easily connect the drain tube of the Verdanium Home to all 40 mm thick plastic drainage pipes. Be-
fore you start with the installation, determine the positioning of the drain clamp.
When installed, the water drain should be visible. Please check that the connection to the Verdanium Home
and the drain clamp is leak-proof with the withdrawal tap open.
Please use the illustration below as a reference for the installation of the drain clamp:
•
Drill a hole (above the odour trap) with a 7 mm drill bit.
•
Stick the foam rubber seal into the drain clamp.
•
Attach the clamp and tighten both screws evenly hand tight.
•
Push the plastic tube 30 mm into the drain clamp connector.
Install the drain clamp above the odour trap of the siphon.
Do not use force when tightening the clamp screws. Install the plastic tube to the Verdanium
Home without any kinks. Do not install any additional fittings such as pressure reducers or
check valves etc. on the tube to the drain clamp
Instruction Manual – Verdanium Home – Ver. 2.1.1 – 12.2020

Drainage

Drain clamp top view
Foam rubber seal
Hole Ø 7 mm
Drain clamp 1/4" tube AD
Art.-Nr.: 1000034
Drain clamp installed
(top view).
39