Drinking Water Withdrawal; Filter Change - Vision Aqua Verdanium Home Gebrauchsanleitung

Drinking water withdrawal

Please open the withdrawal tap.
If the Verdanium Home is in standby mode for more than 15 minutes, it will produce drinking water only
after approx. 15 - 30 seconds. During this time, the filter is rinsed and prepares itself for ultra-pure water
production.
The following messages appear on its display:
PERMEATE PRODUCTION
Automatic
Membrane rinse
ESC ← 080%
After rinsing, the Verdanium Home automatically changes to ulta-pure water production. The following
messages appear on its display:
PERMEATE PRODUCTION
device in operation
ESC ←
To stop ultra-pure water production, close the withdrawal tap.
After the water production finishes, the system prepares for standby mode. The following messages ap-
pear on the display:
PERMEATE PRODUCTION
Automatic
rinsing
ESC ← 050%
The Verdanium Home is now in standby mode.
48 Instruction Manual – Verdanium Home – Ver. 2.1.1 – 12.2020
PERMEATE PRODUCTION
Permeate rinse
ESC ← 030%
PERMEATE PRODUCTION
device in operation
ESC ←
As soon as the message "Attention! Maintenance required! Please replace all filter units!" appears on the
display, the pre- and post-filters need to be changed.
The message „Attention maintenance required! Please replace all filter units!" is only
displayed during the annual filter change.
The semi-annual pre-filter change must be organised by the user.
PERMEATE PRODUCTION
device in operation
Stop the permeate production mode with the
ESC ←
Preparation for
Select in the menu the operating mode "Maintenance Prepara-
Maintenance
tion". Confirm with the
Follow the instructions on the display.
ESC ← → OK
- Close corner valve Disconnect the water supply to your device and open the with-
drawal tap. Confirm with the
- Open withdrawal tap
After you open the withdrawal tap, the pressure in the supply
tube will be reduced. Please wait until the next instruction is
→ OK
shown on the display.
- Disconnect tube
Now disconnect the inlet tube from the angle valve and press
the OK-Button
→ OK
Reset after filter
change:
To reset the filter change interval, you must select in the ope-
Hold keys
rating mode menu the buttons (B) and (–) and hold them for at
least 5 seconds.
"B" and "-" 5s
Instruction Manual – Verdanium Home – Ver. 2.1.1 – 12.2020

Filter change

ESC-Key.
OK-Button.
OK-Button.
to confirm.
49