Setting The Temperature; Touch Settings - STIEBEL ELTRON WSN 10 Bedienung Und Installation

operATIoN
Product description
3. Product description
Operation of the sensor tap is contactless. The water is turned on
and off via a PCB with a proximity sensor. The PCB is supplied
with power as follows:
- WSN 10 via a power supply unit
- WSN 20 via a battery
1 Sensor and LED
2 Touch area
3 Lever for temperature setting
3.1 Function
Water ON
Water OFF
www.stiebel-eltron.com
4. Settings
4.1

Setting the temperature

1
2
3
Your qualified contractor can set a fixed temperature or limit the
setting range to prevent scalding.
4.2

Touch settings

The following settings are made using your finger.
Note
- When making settings, do not place your hands or
- The LED on the sensor will flash/light up during and/
- The green LED confirms the settings have been com-
1 Sensor and LED
2 Touch area
f Move your finger to the touch area from the side or from f
underneath.
other objects within range of the sensor.
or after making the settings.
pleted.
1
2
WSN 10 | WSN 20 | 15