STIEBEL ELTRON WSN 10 Bedienung Und Installation Seite 17

operATIoN
Settings
4.4.2 Continuous draw-off
You can set continuous draw-off for 0.5 to 20 minutes to fill the
washbasin or containers, etc.
Activating continuous draw-off
Factory setting: approx. 2 minutes
2 s 1x
3 s
Deactivating continuous draw-off
1x
Setting continuous draw-off in minutes
Set continuous draw-off from 0.5 to 20 minutes (in increments of
0.5 minutes).
Factory setting: approx. 2 minutes
2 s 1x
3 s 1x
1-40x
...x/1x
www.stiebel-eltron.com
f Touch the touch area for 2 sec- f
onds. The green LED lights up
once.
f Touch the touch area for f
3 seconds. The water will run
for approx. 2 minutes (factory
setting or another preselected
time).
f Touch the touch area briefly. f
f Touch the touch area for 2 sec- f
onds. The green LED lights up
once.
f Touch the touch area for 3 sec- f
onds. The green LED flashes
once (move your finger away
from the touch area before the
red LED flashes). The water
will run when you move your
finger away from the touch
area.
f Touch the touch area until the f
red LED flashes. The number
of flashes corresponds to the
relevant increment:
1x red LED = 0.5 min
2x red LED = 1 min
3x red LED = 1.5 min
...
40x red LED = 20 min
f Move your finger away from f
the touch area when the num-
ber of flashes corresponds
to the required setting. The
setting is confirmed by the ap-
propriate number of flashes.
The water will run. The green
LED then lights up once to
confirm.
4.4.3 Hygiene flush 12/24/48 hours
You can set a hygiene flush to take place 12, 24 or 48 hours after
last use.
The hygiene flush time corresponds to the setting for continuous
draw-off (see chapter „Extended settings / Continuous draw-off /
Setting continuous draw-off in minutes").
Factory setting: OFF
Setting/activating the hygiene flush start time
Note
f Make sure that the drain is always clear to prevent f
overflow due to the hygiene flush.
2 s 1x
25 s 1-4x
1x
... s
Setting the hygiene flush time
See chapter „Extended settings / Continuous draw-off / Setting
continuous draw-off in minutes".
Deactivating the hygiene flush
1x
f Touch the touch area for 2 sec- f
onds. The green LED lights up.
f Touch the touch area for ap- f
prox. 25 seconds (ignore the
red LED after 5 seconds and
green LED after 10 seconds).
The red LED flashes one to
four times. The number of
flashes determines the hy-
giene flush start time:
1x red LED = OFF
2x red LED = ON after 12 h
3x red LED = ON after 24 h
4x red LED = ON after 48 h
f Move your finger away from f
the touch area when the num-
ber of flashes corresponds
to the required setting. The
green LED flashes once to
confirm.
f The hygiene flush is carried f
out automatically after the
last draw-off (according to the
programmed start time).
f Touch the touch area briefly. f
WSN 10 | WSN 20 | 17