Test Running - GREAT WATER QL-Serie Betriebsanleitung Und Wartungshandbuch

Test running

Warning!
Make sure no one is within reach of the rotating pro-
peller and that no objects are in the tunnel before
testing. Do not operate the thruster without the belt
cover installed.
Important!
Make sure that the battery is properly charged be-
fore testing. Voltage, measured at the control unit
(Batt. + and Batt. - / A1, see fig. 5) during operation,
below 10.5 V / 21 V will cause damage to the main
relay.
Warning!
Do not run the thruster(s) out of water.
When the boat is launched:
• Turn the Joystick / Rocker switch to left / push left
arrow button, and the boat moves to port. Turn
Joystick / Rocker switch to right/push the right arrow
button, and the boat moves to starboard. If not,
continue to section " Reversing direction" .
Note! All power consuming equipment should always be
run with care. The engine(s) or the on-board generator
that replenish the batteries must always be running when
the thruster is used to keep the generators charging the
thruster batteries.
Reversing direction
Touch panel, Joystick, Rockerswitch
If the operating direction when using Touch panel, Joy-
stick or Rocker switch is wrong, follow this procedure.
1.
Turn off the main power switch(es).
2.
Switch the wires connected to no. 1 and no. 3 on the con-
trol unit (see fig. 6).
3.
Turn the main power switch(es) for the thruster(s) on and
verify in a safe and controlled manner correct operation
from all thruster control panels.
Downloaded from www.Manualslib.com manuals search engine
Fig. 5
Fig. 6
English
7