Preparation; Fitting Batteries (Not Included); Connecting The Answering Machine - AUDIOLINE 838G Bedienungsanleitung

1. PREPARATION

1.1 FITTING BATTERIES
As your AUDIOLINE 838G stores all information digit-
ally, such as your greeting message, all incoming mes-
sages and the day and time announcement, a battery is
required to safeguard the data during a power cut (or if
the mains power supply should be accidentally un-
plugged from the socket). You will need a 9 V alkaline
block battery.
1. The battery compartment can be found on the under-
side of your answering machine. Remove the screw
and open the battery compartment.
2. Now connect the adapter to the battery. In doing so,
ensure that the polarity is correct.
3. Place the battery in the battery compartment and
close the compartment with the screw.
When the battery is discharged or no battery is fitted,
"bL" is shown in the display. No battery power is re-
quired as long as the answering machine is connected
to the mains power supply.
Downloaded from www.Manualslib.com
(not included)
manuals search engine

1.2 CONNECTING THE ANSWERING MACHINE

Set up your answering machine near to the telephone
and to a mains socket. Connect the small plug on the
telephone cable provided to the telephone jack on the
rear of your AUDIOLINE 838G and connect the other
end to your TAE socket (coding N = for accessories
such as answering machine / telefax). Plug the power
supply into a properly installed mains socket and the
other end into the socket on the rear of your
AUDIOLINE 838G. If you do not have the right connec-
tions, please refer to your telephone network provider.
When switching on for the first time, your new answer-
ing machine needs a few seconds to initialise all the
functions, The display shows "CL" during this time.
After several signal tones, the display alternates be-
tween the following settings:
bl = Battery flat or no battery installed.
— = The time and/or the greeting messages have
not been set up.
00 = No messages have been recorded.
23