Operation - Bartscher 191001 Bedienungsanleitung

6.3 Operation

Water heating
Make sure that the temperature controller is rotated to position
counterclockwise until the end.
•
Pour required amount of fresh water to the device (only up to the maximum mark).
Overfilling of water tank may cause water splashing and burns!
Do not exceed the maximum filling level!
In order to reduce the heating phase time fill the tank with warm water.
In case of cold water the heating time is longer.
•
Place the lid on the tank and put the teapot on it.
•
Connect the device to appropriate single grounded socket.
•
Rotate the temperature controller clockwise. The thermostat allows for stepless
adjustment of water temperature. The following settings may be used: Boiling /
interval boiling (BOIL) / HOT / WARM. Follow the table on page 32.
•
The control light is on during the heating phase.
Water boiling
•
In order to boil water set the temperature to the maximum. Rotate the temperature
controller clockwise to position
•
The control light will come on. It indicates that the device is heating. After several
minutes the water will boil. It is indicated by released steam.
•
When the temperature controller remains in that position the water will continuously
boil and will evaporate eventually.
The released hot steam may cause burns of hands, arms, and face!
Do not remove the lid during boiling.
Downloaded from www.Manualslib.com
CAUTION!
WARNING! Burn hazard!
NOTE!
WARNING! Burn hazard!
manuals search engine
.
- 33 -