Warnings; Mounting Steps - Indel B Sleeping Well Oblo Gebrauchs- Und Wartungsanleitung

When installing, be sure to follow carefully the instructions given in this manual.
The manufacturer declines all responsibilities for damage to equipment or people caused by non-standard system installations or
modifications.
Use the conditioner exclusively for the use envisaged by the manufacturer and make no arbitrary changes or alterations to the appliance.
Never poke your hands inside the grid of the vents and avoid introducing any object into the system.
BEFORE INSTALLING THE SYSTEM, DISCONNECT ALL CONNECTIONS TO THE VEHICLE BATTERY.
Install the roof unit securely to prevent it tipping or falling.
During the assembly phases and the creation of holes in the vehicle, make sure that you do not damage wirings or piping of systems already
installed.
When working near the heat exchangers of the condenser and the evaporator, be careful not to cut yourself on the sharp edges of the fins.
If the electrical wires have to pass through walls with sharp edges, use protective pipes or specific channels.
Securely fasten the electrical wires, paying special attention to their route along metal walls that conduct electricity; also avoid contact with
sharp elements.
Before beginning installation and after positioning the unit on the roof, check that the openings for the air inlet and outlets on the condenser are
not blocked or covered.
Check whether, following the assembly of the conditioner, it is necessary to change the registration of the height of the vehicle indicated in the
log (contact the vehicle manufacturer).
Switch off the conditioner before using automatic washing devices to clean the vehicle.
Disconnect the battery.
Installation operations must be carried out exclusively by a specialised technician who is aware of the dangers connected with installation and
the relative prescriptions.
Before positioning the unit on the roof of the vehicle, check that it is possible to access it and that it can support the weight of the conditioner
you intend to install.
Rest Sleeping Well Oblò on an adequate surface, making sure that it is stable and that the inner diffuser is not damaged.
Remove the hatch from the roof of the vehicle.
Remove the cover of the Sleeping Well Oblò, unscrewing the 10 fastening screws.
Remove the gasket round the hatch opening (if present) and thoroughly clean the edge of the latter, removing all traces of adhesive and
grease.
Fix temporary the Sleeping Well Oblò inside of the hatch; working from the inside of the cabin, fix the supplied frame over the air diffuser
checking that, once the installation is finished, it will cover the hatch space correctly.
Ensure that the front and side slots on the air diffuser remain free after it has been fastened in place.
If this is not the case, trim the upper profile of the frame as much as necessary (see fig.7).
Remove the Sleeping Well Oblò, fit the gasket supplied to the clean edge and apply sealant to the upper surface (see fig.3).
Fit the conditioner in position inside the hatch, paying attention to the newly inserted gasket (see fig.4).
Insert the electrical wires that protrude from the air diffuser between the roof and the inner lining, directing them towards the front of the vehicle
(see fig.4).
ENGLISH
GENERAL WARNINGS

MOUNTING STEPS

28