Eiki EIP-2500 Bedienungsanleitung Seite 64

Troubleshooting (Continued)
Problem
Picture is green on
INPUT 1 (COMPONENT)/
INPUT 2 (COMPONENT).
Picture is pink (no green)
on INPUT 1 (RGB)/INPUT
2 (RGB).
Picture is too bright and
whitish.
The cooling fan becomes
noisy.
The lamp does not light
up even after the
projector turns on.
The lamp suddenly turns
off during projection.
The image sometimes
flickers.
The lamp needs much
time to turn on.
Picture is dark.
This unit is equipped with a microprocessor. Its performance could be adversely affected by incorrect operation
or interference. If this should happen, unplug the Unit and plug it in again after more than 5 minutes.
60
EIP-2500_EN_PR_l
• Change the input signal type setting.
• When you cannot select an input signal type, select "Color is faded
or poor" in the "Help" menu, after selecting an item other than
"sRGB" in "Picture Mode", and then select an input signal type.
• Image adjustments are incorrectly set.
• When temperature inside the projector increases, the cooling fan
runs faster.
• The lamp indicator is illuminating in red.
Replace the lamp.
• Cables incorrectly connected to the projector or the connected
equipment works improperly.
• Select "Vertical stripes or flickering image appear" in the "Help"
menu and make the necessary adjustments.
• If this happens frequently, replace the lamp.
• The lamp will eventually need to be changed.
While the remaining lamp life draws to a close, replace the lamp.
60
Check
05.7.5, 1:29 PM
Page
46
39, 46
40
–
48, 51
23–26
46
51
51