Dishwasher Installation Steps - Blaupunkt 5VT710NA Montage- Und Gebrauchsanweisung

Dishwasher installation steps

1 Install the furniture door to the outer door of the dishwasher using the brackets provided. Refer to the
template for positioning of the brackets.
2 Carefully adjust the tension of the door springs by using an Allen Key. Turn in a clockwise motion to
tighten the door springs on both sides of the door. Failure to do this could cause damage to your dishwasher
(Illustration 2).
3 Connect the inlet hose to the cold water supply .
4 Connect the drain hose. Refer to diagram . (Figure 6)
5 Connect the power cord .
6 Affi x the condensation strip under the work surface of cabinet. Please ensure the condensation strip is fl ush
with edge of work surface.
7 Place the dishwasher into position. (Illustration 4)
8 Level the dishwasher. The rear food can be adjusted from the front of the dishwasher by turning
the Allen screw in the middle of the base of dishwasher use an Allen key (Illustration 5A). To adjust
the front feet, use a fl at screw driver and turn the front feet until the dishwasher is level (Illustration 5B).
9 The dishwasher must be secured in place. There are two ways to do this:
A. Normal work surface:Put the installation hook into the slot of the side plane and secure it to the work
surface with the wood screws (Illustration 6).
B. Marble or granite work top:Fix the side with Screw. (Illustration 7).
3
2
1
4
Figure7
52