Caring For The Dishwasher - Blaupunkt 5VT710NA Montage- Und Gebrauchsanweisung

Remarks:
- Inspect the fi lters for blocking after every time the dishwasher has been used.
- By unscrewing the coarse fi lter, you can remove the fi lter system. Remove any food remnants and clean
the fi lters under running water.
NOTE:
The entire fi lter assembly should be cleaned once a week.
Cleaning the Filter
To clean the coarse fi lter and the fi ne fi lter, use a cleaning brush. Reassemble the fi lter parts as shown in the fi gures on the last
page and reinsert the entire assembly in the dishwasher, positioning it in its seat and pressing downwards.
When cleaning the fi lters, don't knock on them. Otherwise, the fi lters could be contorted
WARNING!
and the performance of the dishwasher could be decreased.

Caring for the Dishwasher

The control panel can be cleaned by using a lightly dampened cloth.
After cleaning, make sure to dry it thoroughly.
For the exterior, use a good appliance cleaning care product.
Never use sharp objects, scouring pads or harsh cleaners on any part of the dishwasher.
Cleaning The Door
WARNING!
Protect Against Freezing
please take frost protection measures on the dishwasher in winter. Every time after washing cycles, please
operate as follows
1.Cut off the electrical power to the dishwasher.
2.Turn off the water supply and disconnect the water inlet pipe from the water valve.
3.Drain the water from the inlet pipe and water valve. (Use a pan to gather the water)
4.Reconnect the water inlet pipe to the water valve.
5.Remove the fi lter at the bottom of the tub and use a sponge to soak up water in the sump.
NOTE:
If your dishwasher cannot work because of the ice,
please contact professional service persons.
Cleaning the Spray Arms
It is necessary to clean the spray arms regularly for hard water chemi-
cals will clog the spray arm jets and bearings.
To remove the upper spray arm, hold the nut, rotate the arm clockwise
to remove it.
To remove the lower spray arm, pull out the spray arm upward.
Wash the arms in soapy and warm water and use a soft brush to
clean the jets. Replace them after rinsing them thoroughly.
To clean the edge around the door, you should use only a soft warm, damp cloth. To avoid
penetration of water into the door lock and electrical components, do not use a spray cleaner
of any kind.
Never use a spray cleaner to clean the door panel as it may damage the door lock and
electrical components.
Abrasive agents or some paper towels should not be used because of the risk of
scratching or leaving spots on the stainless steel surface.
47
Open